I logged in to write this post, actually, and saw that my AB 2014 post was still languishing in the "Drafts" folder. So I grabbed a cup of coffee and panicked. Effectively.
That was this morning. Since then, deep breaths have been taken and the coffee has been replaced with green tea. Which means I can finally get on with writing what I meant to post all along -- how I built my 5-foot-long gun for Zarya.
So, in order, this is how I put together Zarya.
Qualifications: huge and lightweight
Tools: screenshots for base sketching, Shopbot CNC Router, lasercutter, hand tools, lots of paint
|The Gun. My reference for everything.|
|Divided the gun into two layers -- a base layer of effectively cardboard, lasercut to the scaled specifications of a reference, and an overlapping layer of foam, cut on a ShopBot. The base layer became black and the foam white.|
|I needed some way to hold a very light and possibly unwieldy gun. Given that cardboard is not the most stable of materials when cut into long thin rectangular-like things, I opted not to use the actual handhold configuration of the in-game gun. Instead, I picked up two of these cardboard briefcases to sandwich between the two sides of the gun and serve as handholds. This was doubly useful because it turned out that the lasercutter I was using was only big enough for half of the gun at a time (see pic above). The briefcases gave me something solid to anchor the two sides on.|
|And so I did. The base layer in this photo has just been Elmer's glued onto the two briefcases (throwback to elementary school. Man.) The books are positioned above each briefcase and are being used to weigh down the parts until they set. All in all, this took about a day -- I was very cautious to make sure it set properly.|
|The final, glued result. Now it can stand on its own!!|
|The next step was to paint the overlayer of foam white. Here, I learn that foam needs to be coated before it can be spraypainted...or even primed. If one does not seal the foam, it starts to melt. Luckily, this was a test piece.|
|I spend a few hours one weekend afternoon sealing all of my foam pieces. Two coats of Mod Podge was about right. I have the sneaky suspicion I could have used Elmer's Glue to the same effect.|
|After the Mod Podge, I took the foam outside (in the wind...yeesh) to give it the first coat of paint. I decided at this point that the primer was unnecessary. The paint looked just fine.|
|The second coat of paint was applied in a loading dock. Spray-painting in the wind is, as I suspected, not fun.|
All of the little details on the foam decals were added by hand using acrylic paint and foam brushes.
And voila! My gun is finished!
Qualifications: Pink and short
Tools: Bleach, hair dye, and a very patient friend
|I think, at this point, the results speak for themselves.|
The Badass Look
Tools: Amazon, Under Armour, and things I normally like to work out in.
|Welcome to the Gun Show|
|Guns and mood lighting.|
|And, of course, no cosplay is complete without these lovely ladies.|